This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
playground_version_12 [2019/12/28 13:38] julien |
playground_version_12 [2019/12/29 11:41] julien |
||
---|---|---|---|
Line 65: | Line 65: | ||
====== Installation des logiciels ====== | ====== Installation des logiciels ====== | ||
- | **Pd-l2ork (Fork de pd-extended)** | + | ===== Pd-l2ork (Fork de pd-extended) ===== |
+ | |||
+ | ==== installation ==== | ||
Pour l'instant pas de support pour driver jack (vraiment étrange!) | Pour l'instant pas de support pour driver jack (vraiment étrange!) | ||
Line 154: | Line 157: | ||
thanks to Marc Lavallée - http://disis.music.vt.edu/pipermail/l2ork-dev/2019-December/002303.html and Jonathan Wilkes (I haven't tested your method): http://disis.music.vt.edu/pipermail/l2ork-dev/2019-December/002305.html | thanks to Marc Lavallée - http://disis.music.vt.edu/pipermail/l2ork-dev/2019-December/002303.html and Jonathan Wilkes (I haven't tested your method): http://disis.music.vt.edu/pipermail/l2ork-dev/2019-December/002305.html | ||
https://askubuntu.com/questions/1138928/bionic-18-04-what-packages-to-use-for-slv2-jack-slv2-jack-slv2-jack | https://askubuntu.com/questions/1138928/bionic-18-04-what-packages-to-use-for-slv2-jack-slv2-jack-slv2-jack | ||
+ | |||
+ | |||
+ | ==== librairies & externals ==== | ||
+ | |||
+ | 1-check sfread~ devenu sfread2~ (mmoonlib) | ||
+ | |||
+ | 2-percolate - le code est à réécrire pour 64bits... ne se monte pas!! | ||
+ | |||
+ | 3-susloop~ dans bsaylor | ||
+ | |||
+ | ===== Pd-vanilla 0.50 ===== | ||
+ | |||
+ | suite à des petits bugs avec pd-l2ork nous avons décidé de compiler pd-0.50 | ||
+ | |||
+ | ==== installation ==== | ||
+ | télécharger les sources sur http://puredata.info | ||
+ | |||
+ | <code> | ||
+ | ./configure --enable-jack | ||
+ | make | ||
+ | sudo make install | ||
+ | </code> | ||
+ | |||
+ | Ensuite il faut utiliser find externals (choisir un path/chemin d'installation) pour télécharger les librairies d'objets (merci deken!) | ||
+ | rentrer les paths dans preferences/path | ||
+ | |||
+ | |||
+ | |||
+ | |||
===== Icecast2 serveur ===== | ===== Icecast2 serveur ===== |